Tronxy X5SA Pro Z Axis Spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This spacer was created to be printed without supports. This is meant to be put in the two holes near the Z axis…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 557
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This spacer was created to be printed without supports. This is meant to be put in the two holes near the Z axis thread rod. The spacer goes around the bearing at the top of the axis making it flush with the frame.
When making your Z axis even, be sure to remove the spacers before homing the Z.
I use Klipper and homing the Z moves the bed down before homing the X and Y. This is when I remove them. If you do not remove them, they will hit when the Z is homed.
Print Settings
Supports:
No
Filament:
ERYONE PLA
Matte Green
Notes:
Print with the alignment rods facing up.
Category: 3D Printer Accessories