LightLock Clip – Print in Place Curtain Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print-in-place clip that snaps over two curtain edges to block light leaks; no supports or assembly.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 1
- Wyświetlenia
- 66
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Share Alike
Print-in-place LightLock Clip
Snaps over two curtain edges to close the light gap. Rounded ends prevent snagging and the slim profile lets the panels glide on the rod.
Fit variants (mouth opening)
TightFit 0.50 – very snug; harder to install but locks in firmly.
TightFit 0.75 – snug, good hold.
Regular 1.00 – balanced fit for typical blackout fabric.
EasyFit 1.25 – easier on thicker/rougher fabric.
Geometry variants
Standard – straight channels for a smooth slide.
Dual-Grip – added mid contact bump for extra hold along the span.
Printing
Material: PETG recommended (PLA works).
Orientation: flat as modeled, channels up.
Layer height: 0.2 mm (0.12 mm for a cleaner finish); 3 perimeters; 20% gyroid.
Temps: 205–215°C / 60°C (PLA) or 240–250°C / 80°C (PETG).
No supports; cooling on.
Files
Standard Print-in-place STL set: 0.50, 0.75, 1.00, 1.25.
Dual-Grip STL set: 0.50, 0.75, 1.00, 1.25.
STEP for remixes.
Use
Start with Regular 1.00; go tighter or looser as needed.
Place a clip every 30–40 cm along the curtain overlap.
Share a Make with your window size so I can tune future variants.