1 / 2
LightLock Clip – Print in Place Curtain Clamp — image 1
1 / 2

LightLock Clip – Print in Place Curtain Clamp

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Print-in-place clip that snaps over two curtain edges to block light leaks; no supports or assembly.

Rating
0 / 5
Likes
1
Downloads
21
Makes
1
Views
66
Reviews
0

Updated at source:

Model information

Category
Home Decor
License
Creative Commons — Attribution — Share Alike

Print-in-place LightLock Clip

Snaps over two curtain edges to close the light gap. Rounded ends prevent snagging and the slim profile lets the panels glide on the rod.

Fit variants (mouth opening)

  • TightFit 0.50 – very snug; harder to install but locks in firmly.

  • TightFit 0.75 – snug, good hold.

  • Regular 1.00 – balanced fit for typical blackout fabric.

  • EasyFit 1.25 – easier on thicker/rougher fabric.

Geometry variants

  • Standard – straight channels for a smooth slide.

  • Dual-Grip – added mid contact bump for extra hold along the span.

Printing

  • Material: PETG recommended (PLA works).

  • Orientation: flat as modeled, channels up.

  • Layer height: 0.2 mm (0.12 mm for a cleaner finish); 3 perimeters; 20% gyroid.

  • Temps: 205–215°C / 60°C (PLA) or 240–250°C / 80°C (PETG).

  • No supports; cooling on.

Files

  • Standard Print-in-place STL set: 0.50, 0.75, 1.00, 1.25.

  • Dual-Grip STL set: 0.50, 0.75, 1.00, 1.25.

  • STEP for remixes.

Use

  • Start with Regular 1.00; go tighter or looser as needed.

  • Place a clip every 30–40 cm along the curtain overlap.

  • Share a Make with your window size so I can tune future variants.

Tags