Camo Starter Edge Clip spacer for 3/16th and 1/8th deck gaps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacers for use with the Camo Starter Clips that helps you get consistent gaps between grooved composite deck boards.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 87
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Using Camo Starter Clips, it's difficult to get the proper gap between deck boards. Specifically, Fiberon composite decking used with the Camo Edge Clips hidden deck fastener system. The Fiberon manufacturers install instructions call for using the edge clips for the first board. If there is a picture frame on the outside of your deck, you'll need to space the edge clips consistently. This is difficult without the use of spacers.
The starter clip is pressed into the spacer, then held against the picture frame board while the screw is installed or a pilot hole is drilled. I recommend a pilot hole. The Camo Starter clips come with screws that use a T15 star drive. If you don't have a T15 magnetic bit, it's a pain to get things in the right spot without a pilot hole.
I've used the 3/16 version, but I have not used the 1/8th version.
I recommend using deck spacers along with deck clamps when installing.
Full disclosure, I don't like Camo Edge Clips, and would not recommend them. I used them because I bought them. If you're in the same boat, this may make your life easier. If you haven't already bought em, I would recommend using Starborn pro plug hidden screws for the first grooved board. The Fiberon specs call for pinning the center of the board with screws even if you're using the hidden camo fasteners, so there's one less system to buy into.
Also - the edge clips don't come with a T15 star drive. That's just dumb.