RockShox Super Deluxe Coil RT 160mm Lockout
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalistic lockout on the shock. Requires a shift/brake cable.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 66
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Requires:
Brake/shifter cable to attach.
I used a shifter cable but included a model for the other common cable type.
Heat shrink tubing or tape to protect the exposed cable ends
Installation Instructions:
Print the appropriate part per the cable you have. Modify the model if required.
I included a model for brake cables but have not actually printed that one so please note it might perform slightly differently or require some finessing during installation.
Thread cable through the printed part and into the shock until the barrel end of the cable is seated inside the cavity of the printed part. If things are not fitting due to hardware differences, modify the part/model.
With the cable pulled snug and the lever in the "T" orientation, gently tighten the set screw on the shock.
Test that the lever fully locks and then unlocks the shock.
If seated on the bike, the lock actuation should be a simple depress down motion with a middle finger pulling the rear part of the lever forward.
The unlock actuation should be a simple flick forward.
Repeat steps above as required before trimming off cable excess. Use heat shrink tubing to protect exposed wire ends from fraying further and poking you while riding.
You can tuck the exposed cable into the set screw portion of the shock if desired but I found this often damages the cable to where I am not able to use it again after full shock disassembly for servicing. I prefer leaving the cable clean cut and slightly exposed with a heat shrink covering.
Optional: Fill the left over hole with RTV and fair smooth. Do not pack the cavity if you do this!