Cartographer setup helper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Z offset gauge for checking the distance between your nozzle and the Cartographer V3 or V4 probe.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
This helper gauge should help during your initial Cartographer probe installation. When your nozzle is just touching the shorter spring (about 20mm above the bed), the cartographer should sit flush with the longer spring.
Measure the gauge with calipers first to ensure it is the correct size. The shorter spring should measure 20mm, and the longer should measure 22.8mm. As long as the spring is accurate, this will put your cartographer to nozzle offset at 2.8mm, right in between the 2.6-3mm goldilocks zone required by Cartographer.
Print as is with no supports, with 3 walls. Keep in mind that if your printer isn't relatively dialed in, then measurements might be a tad off.
I also included some ships in case your Cartographer sits too high.