Aquaristic stand for 60mm Sodastream CO2 bottle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stand for aquaristic CO2 bottle
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this holder for my aquarium.
It is intended for sodastream bottles with a diameter of 60mm.
The bottle is not in the middle of the holter !!!
I deliberately designed it so that the bottle is a little further back to balance the protruding fitting.
The holder can be attached to the surface with 2 screws. Basically, it is surprisingly stable for me even without screws.
The stability can vary depending on the CO2 fitting used.
For safety reasons, it should be screwed down so that the bottle cannot accidentally fall over.
I printed it with a 0,4mm nozzle with ABS.
But other plastics are of course just as suitable for this.
I used the following settings:
-3 external wall lines
-Layer thickness 0,2mm
-7 bottom an 7 top layers
-15% infill
Have fun with the model :-)