2024 ZX-10R Mirror Hole/Block Off
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use to block off the hole from using after market mirrors. READ DESCRIPTION
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Standard Digital File License
I used to this to help stop water and dust from getting inside the hole that was left behind from the wire for the turn signals.
Print this in TPU ONLY so you don't damage your paint! As usual, by using this, you accept any damage you may cause, I'm not responsible for any damages.
TPU is soft and flexible, making it easier to install, ( although it still can be a bit difficult ), and a lot less likely to cause any damage. It also helps seal against the bike by allowing it to flex and pull closer to the gaps.
Print at 15% infill with at least a .4 nozzle and .20 layer height. If you struggle to install it, maybe drop it down to 10% infill. Make sure to keep the top layers to at least 3 to help hold up against the outdoors and warping. No Supports are needed while printing.
If you use, please post a photo with your make :)