Speaker Adapter for Hyundai IONIQ 5 SE 2024 – Rear Door
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drop-in adapter to fit Kenwood KFC-1698RS speakers into the rear doors of a 2024 Hyundai IONIQ 5 SE, with correct positi
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 275
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Drop-in adapter to fit Kenwood KFC-1698RS speakers into the rear doors of a 2024 Hyundai IONIQ 5 SE, with correct positioning against the door duct and weatherstripping seals on both faces.
This adapter replaces the factory rear door speakers with the Kenwood KFC-1698RS (Crutchfield link).
Crutchfield includes generic adapters, but they don't fit well in this rear location. This adapter does two things: matches the diameter and bolt pattern between the door frame and speaker, and positions the speaker correctly to seal against the duct in the door trim panel.
I added self-adhesive weatherstripping to seal both the door frame side and the trim panel side.
The adapter prints in two pieces that are glued together. I maximized the gluing surface area for a strong bond. I printed in ABS and used acetone-dissolved ABS as solvent weld — this thickens the acetone, improves gap filling, and slows evaporation slightly. MEK is a good alternative with a longer working time. CA glue or epoxy will also work if you're not using ABS.
Three M2×5mm screw holes are provided to hold the pieces in alignment while the glue sets, but they are not structural — the glue joint carries the load.