Back-Panel Fun replacement for 80x80x25mm cases
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for replacing the fan on the rear panel of Creative K1 Series printers with a more common version 80x80x25mm
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 100
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
An upgrade for the Creality K1 printer series.
The new mount requires cutting out a section of the case and installing a new fan mounting frame, measuring 80x80x25mm.
For easy fan installation, I used common anti-vibration mounts, but you can use regular screws if desired.
To mark the cutting area, it's easiest to place a clamping bar against the back panel.
Cutting the honeycomb ribs from the back panel is most easily done with a standard wood chisel.
There are two options for each part.
Part 1 (mounting frame):
Option 1 - involves tightening the rear frame directly into the plastic with screws, without using threaded bushings (fused-in);
Option 2 - involves tightening the rear frame with screws into threaded bushings (fused-in), measuring M3xL6.3xOD4.6;
Part 2 (clamping plate):
Option 1 - involves only mounting the fan, without using an air filter;
Option 2 - involves mounting the fan, including a space for using the Creality K1 Max air filter.
Assembly requirements:
DIN7991M3*10mm screws: 6 pcs.;
Threaded bushings (fused-in) M3xL6.3xOD4.6: 6 pcs. (Optional);
Creality K1 Max Carbon Filter (HEPA13 Blurolls): 1 pc (Optional).
Slicer settings
Nozzle: 0.4
Line height: 0.15
Line width: 0.4
Supports: Yes
Brim/Raft: No
Infill: 50%
Walls: 3
Top/Bottom layers: 6
Material: Black ABS M8 from PrintProduct (I used PETG for the prototype and found no problems).
Material consumption, including supports (if necessary):
Part 1 (mounting frame):
Option 1 - 55.33g;
Option 2 - 52.32g;
Part 2 (clamping plate):
Option 1 - 21.10g;
Option 2 - 35.72g.
Installation:
Print the required parts kit.
If using threaded bushings, install them in place.
Apply the clamping bar, aligning the honeycomb structure, and mark the unnecessary ribs for cutting.
Cut out the unnecessary stiffeners.
Apply the clamping bar, aligning the honeycomb structure, and mark the main hole and screw holes.
Cut out the main hole and additional holes for the mounting screws. Additionally, you need to finish the edges to remove any protruding elements.
Install the holding frame in place.
Reinstall the clamping bar.
Secure with the lag screws. !!!Do not overtighten.
Install the fan.
You are beautiful!