Haylou S30 (S35/S40 maybe) Aftermarket Earpad Ring Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3D printed Earpad ring mount for the earpads that you can buy off Aliexpress for the Haylou S-series headphones.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Share Alike
My original "leather" earpads started disintegrating, so I got myself some of the custom aftermarket ones for like 6$ a set. I got the velvet ones and premium ones (leather + soft padding). They are extremely comfortable, but because of the size, foam and stuff, the quality of the sound and ANC becomes worse. The bass is less.
Anyway, I needed a way to put these on without destroying my old earpads which I sometimes use. The earpad sits on M3x6 Countersunk screws. In total you will need 8 screws.
INSTRUCTIONS:
1. Look at the Photo №2 at the orientation of the clips and print them this way (maximum strength). If you have ashesion issues (first of all fix that) you can print them on their backs.
2. Take the "Clip holder" and the clips. Insert 4 clips into the Clip holder (look at the Photo №3 at the recommended places to put the clips in), press fit them with pliers (or press against the table) and secure with super glue. Make sure to wait for it to dry!
2.1 P.S. You can do all 6 clips, but 4 will be more than enough + will be easier to put it on and take off + if one of them breaks for some reason, you can just install a new clip without reprinting the whole thing.
3. Put the earpad onto the fat piece ("Main Body Ring" in the slicer), stretch it on there. Keep in mind the front and top according to the photo.
4. Put the part with the clips on top of the thing. Be sure to align all the screw holes together. After that, it is better to poke the holes in the earpad's leather with something super sharp and pointy. I used a stitching awl. Then you can start screwing in the screws through the holes. Tighten all that down and Bob's your uncle.
It definitely fits the Haylou S30. It may fit the S35 and S40, but you will have to test it.
Happy printing!
