Eldritch Horror character frames and insert for small expansion box fit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this model to fit in a small box expansion. It contains all character tiles, frames, missions and cards
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Eldritch Horror character frames and insert for small expansion box fit
I designed this model to fit in a small box expansion. It contains all character tiles, frames, missions and cards
Long thin frame:
Can contain 54 characters. If you have all expansions you need to put the 55. character in one of the stands.
Print tips:
- Print this part on the largest face.
- No supports needed
Mission box:
2.0 is on the picture, but I redesigned it in 3b for easier card access and symmetry.
3b is not tested whether they fit or not since I haven't printed it yet.
Print tips:
- Choose either models DO NOT PRINT BOTH only one is needed
- If you print 2.0 please note that the part is 2 subparts, so when you slice it you need to choose it as a continuous part else the buttom will break off. This issue is fixed in 3b.
- No supports are needed.
- The heatbed should be 65 degrees for better results. (Throughout the print)
Singular frame:
This frame is a redesign of the model from SKxyz. This is one part instead of 3, but without the lid (original lid is still compatible). 4 of these will fit in the box. If you need more they can also fit within the long frame, but its not recommended.
Print tips:
- Print from the base and up. I printed this without supports though if you have a low quality printer you might need supports for the airtime at the top when it crosses to connect the two pillars.