Cartographer V4 Mount for Sovol SV08

Cartographer V4 probe mount designed for the Sovol SV08.

Print:
1x (Cartographer v4 Mount)
2x (3.25mm tall ID 3.2mm OD 6mm Spacer) (these spacers slide on the screws that came with your cartographer mount)

Probe Offsets (add these to your [cartographer] section in printer.cfg):

x_offset: 27.4732
y_offset: 5.0986

Print Settings:
I printed the mount three times, one out of PLA >>> then using the PLA mount; I printed the next of ASA >>> then using the ASA mount; I printed the final out of PPA-CF. If you have a printer that can go up to 280-320 degrees to print carbon fiber, you should go ahead and print your carbon fiber version immediately. If there are people who are not able to print a mount out of PPA-CF, let me know; I could start shipping them out. Contact info at the bottom.

- Material: PPA-CF or ASA recommended (PPA-CF preferred for heat resistance near hotend and heatbed)

- Layer height: 0.2-0.4mm

- Infill: 100%

- Supports: no

- Extrusion multiplier: 1.07 PPA-CF, 1.02 ASA

Important Notes:

- The probe will sit 2.85mm above the print bed when mounted (+/- some expansion or shrinkage).

- You will need to trim a small section of the injection-molded front faceplate that houses the front blower fan to prevent the Cartographer's cable from interfering with it. (see images here or in the google drive folder.)


The full setup guide (.MD file) is in the Google Drive link below. It covers everything needed to get the Cartographer V4 working on the stock Sovol Klipper fork without flashing MCUs or using an ST-Link. I tested and troubleshot a lot of configurations over several weeks but didn't have time to organize everything with photos for each step, so I had AI help organize my notes into a structured guide. The guide covers: V4 firmware patches, printer.cfg configuration, temperature compensation calibration, edge-of-bed interference fix, macros, and troubleshooting.
Google Drive: https://drive.google.com/drive/folders/16JUU-c2n7Ofv68aAkgY2NzWCTkhiOp1m?usp=sharing

Please let me know if you run into any issues with this mount; I tend to respond pretty quickly. If you would like to use this for commercial use, you are required to buy the license from me for $30, I can provide the .SLDPRT and .SLDASM parts if you need them. 

Thank you.

Contact: [email protected]