Light Mount with Cable channel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a light mount for typical batterie bike lights. It allows to route some cables bellow it.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a handlebar mount for standard battery-powered bike lights with an integrated cable routing channel underneath the mount. It fits Fischer, Aldi, Lidl, etc. front lights.
The design allows cables (e.g. brake, gear) to run neatly below the light mount, keeping the handlebar setup clean and organized.
It works with many standard front lights that use the common slide-in interface found on battery bike lights.
Features
Compatible with many standard slide-in bike light mounts
Integrated cable channel under the mount
Helps keep the handlebar tidy
Simple and sturdy design
Easy to print
The reflector versions allow you to mount additionally small reflectors on the same mount (https://www.amazon.de/MFC-PRO-Fahrrad-Reflektor-Set-hinten-Sattelst%C3%BCtze/dp/B08ZM98V34)
Print Settings
Recommended:
Layer height: 0.2 mm
Walls: 3–4
Infill: 30–40 %
Material: PETG recommended for outdoor durability
PLA can work but may soften in hot sunlight.
Mounting:
1 × M4 screw
1 × M4 nut
The screw clamps the mount around the handlebar while leaving space for the cable to run through the channel underneath. Place the nut on the bottom and the skrew on the top.
Notes
Designed for standard battery light slide mounts commonly used by many bike lights.
Make sure the cable diameter fits the routing channel before printing. If you need different sizes, please contact me!