1 / 6
HP EliteDesk 3.5"HDD Caddy/Mount w/Screw holes — zdjęcie 1
1 / 6

HP EliteDesk 3.5"HDD Caddy/Mount w/Screw holes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Designed for the HP EliteDesk 300 Hard drive mounts Allows your drives to be mounted Securely without case mods

Ocena
0 / 5
Polubienia
4
Pobrania
23
Wydruki
0
Wyświetlenia
139
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

I tried using the original single drive model (By Scubadiver48) to position my Drives in my Computer horizontally, However after multiple failures of the pegs on the side when trying to fit my drive into I decided to remix it. This model uses their base design but cuts a hole in the mounting pegs on the 4 sides to make room for a Screw hole. This lets you connect the drive to the caddy and still have it fit into the drive slot without any more frustrations. This lets you use basic HDD drive screws to hold the drives in place with the drives fitting snug inside.

Print Settings

Printer: Flashforge Adventurer 5m

Filament: Basic PETG worked for me But PLA should work as well

Quality: 0.2mm Layer Height

Walls: 4

Infill: 10% Rectilinear

Supports are required

Tree (Auto)

With a Top Z distance of .23mm and Bottom Z distance at .23mm

With the "On build plate only" and "remove small overhangs" unchecked worked for me.

Filament used is 5.85 m

Print time was Roughly 0h 45mins

Any feedback is always appreciated it! 

Tagi