1978 Ford Bronco Bench Seat Lever
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaces the plastic seat lever on Gen 2 Broncos. Might also fit other FORD front seats from the era.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
My 1978 FORD Gen2 Bronco restoration project was missing a plastic seat lever on the passenger side. My modeling isn't the highest quality, and some measurements may be slightly off. But you can't purchase these even from LMC, and for just a few cents worth of filament, the modeled part is just as comfortable to use. Original part is on the left, printed part is on the right.
I suggest printing with the flat side on the build plate, and with adaptive layer height to really smooth out the top curve. Print in ASA for maximum heat/UV protection. You can really go all out and sand/fill this too! If you have problems with bed adhesion, you may need to add a brim since the part is so small.
This is the first of many models I intend to upload as I continue my restoration. Check back later for more!