1 / 2
WPL JJRC B1 B16 Q60 Q61 etc rear bumper base remixed for adding weight — zdjęcie 1
1 / 2

WPL JJRC B1 B16 Q60 Q61 etc rear bumper base remixed for adding weight

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I really liked both designs I remixed from, but I saw a bit of an idea to try. These WPL and JJRC trucks are pretty…

Ocena
0 / 5
Polubienia
8
Pobrania
45
Wydruki
0
Wyświetlenia
333
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I really liked both designs I remixed from, but I saw a bit of an idea to try. These WPL and JJRC trucks are pretty darn light weight. Which, in theory, could be bad for traction. And in some models they're a bit top heavy and can easily tip over. So in order to combat both problems with a cheap solution, I decided to add weight in the form of copper BBs or lead shot to empty areas anywhere I could find them in the chassis beams and bumper area. As they were, it was not nearly enough to add significant weight. So I remixed and rebuilt to increase empty volume for adding BBs, lead shot, etc and gluing in place with hot glue or epoxy or whatever you like.

I also saw the thin walls for the screws as a weak point so I increased the amount of plastic available for screws to bit into.

It should work with any of the similar 1/16 scale metal C channel chassis trucks I think.

6/10/19: Added V2, I just discovered that some models of truck bed have a protruding tab that needed space to insert. So the choice is to either clip the tabs off the truck bed or create slots for them, so I created slots. Hopefully nobody ran into that problem before I noticed it.

6/16/19: Apparently some beds didn't work with the previous v2 so here's v2.1.

Category: R/C Vehicles

Tagi