WPL JJRC B1 B16 Q60 Q61 etc rear bumper base remixed for adding weight
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I really liked both designs I remixed from, but I saw a bit of an idea to try. These WPL and JJRC trucks are pretty…
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 46
- Makes
- 0
- Views
- 336
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I really liked both designs I remixed from, but I saw a bit of an idea to try. These WPL and JJRC trucks are pretty darn light weight. Which, in theory, could be bad for traction. And in some models they're a bit top heavy and can easily tip over. So in order to combat both problems with a cheap solution, I decided to add weight in the form of copper BBs or lead shot to empty areas anywhere I could find them in the chassis beams and bumper area. As they were, it was not nearly enough to add significant weight. So I remixed and rebuilt to increase empty volume for adding BBs, lead shot, etc and gluing in place with hot glue or epoxy or whatever you like.
I also saw the thin walls for the screws as a weak point so I increased the amount of plastic available for screws to bit into.
It should work with any of the similar 1/16 scale metal C channel chassis trucks I think.
6/10/19: Added V2, I just discovered that some models of truck bed have a protruding tab that needed space to insert. So the choice is to either clip the tabs off the truck bed or create slots for them, so I created slots. Hopefully nobody ran into that problem before I noticed it.
6/16/19: Apparently some beds didn't work with the previous v2 so here's v2.1.
Category: R/C Vehicles