HexStopper - TPU Door Stopper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A new version of the original HexScraper, except for stopping doors, and made out of TPU.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my very last minute entry into the TPU Flex it challenge! Hope you like it!
This model can be used for doors of any (reasonable) height from the ground, as it is pretty tall.
Print Settings:
Material: TPU 95A
Infill: 10%
Layer height: 0.16 mm
Infill pattern: Gyroid
Supports: No
Use the "Avoid Crossing Walls" function if using OrcaSlicer, PrusaSlicer, or other similar types.
Use the "Combing" function if using Cura.
These functions make the extruder not cross over through the hexagons, so there is no stringing, especially with TPU.
There are two models; the flat one is for slipperier floors, or flat ones, and the other, grooved one is for textured floors, like carpet to get a good grip.
This print takes ~4 Hours due to being printed from TPU, so set aside some time to do this.
Well, that's It for me. Time for you to print it now.
P.S. If you like this model, please consider posting a make or comment