1 / 3
[WIP] Front Brakes for 1/10 RWD Drift RC — zdjęcie 1
1 / 3

[WIP] Front Brakes for 1/10 RWD Drift RC

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

skrrrrrrrrrt

Ocena
0 / 5
Polubienia
9
Pobrania
33
Wydruki
0
Wyświetlenia
386
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

This project allows you to install front brakes on your 1/10 RWD RC drift car. These allow the car to stop much shorter than rear brakes alone, and everyone who has tried the car agrees that it is cool and fun being able to lock up all four wheels going into a turn.

It was designed to be used with an MRC-equipped Tamiya TT02 but likely compatible with other models. I wanted this system to be lightweight, cheap, and easy to implement. The system functions by using two small servos (EMAX Digital Servo ES9251) and a TPU "shoe" to scrub the inside barrel of the wheel. Wires are routed through the front differential housing as shown in the attached photos.

I do not have the time to experiment and finalize the design, but this does work reasonably well as-is. The user will have to mix the channels in their transmitter to their preference, and there is a lot of room for improvement in the shoe design/material. If you chose to work on this project I would love to see how it works for you and any improvements you make. I'll update the models as time permits.

The functionality of the brake is dependent on the ID of the wheels, and I designed them to work with my 1/10 drift wheels below:

Tagi