Body, insert rings, and tool for Rockler router plates
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The body is installed with the standard table screws, and then the inserts can be installed with the tool.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This uses the same idea as the Jessem router plates, but is designed for Rockler Pro Plates. The insert holder is mounted to the Pro Plate to allow the inserts to be used.
I used white UV resin to highlight the text and alignment points.
Printing was done with ABS.
Note that the insert holder required printing supports in the area where the insert is installed. Since the holder and inserts need to be flush, I ended up mounting the holder ring on a lathe (I added a centering ring to align it with the tailstock dead center) and turning the holder edge to remove enough of the support material for the insert to fit flush.
I also needed to clean the template guide plate of leftover support material using a 35 mm Forstner bit (Porter-Cable 9-Piece Router Template Guide Set PC42000).
For the tool I used:
2 ea: 6x19x2mm Thrust bearing (+ washers) e.g. needle bearings | McMaster-Carr
1 ea: Shouler bolt e.g.Bolt Depot - Metric shoulder bolts (imported), Class 12.9 alloy steel black oxide finish, 6mm shoulder (5mm x 0.8mm thread) x 25mm
1 ea: M5 Hex nylon insert lock nut
2 ea: M3 x 10mm female thread guide pins. I got them on AliExpress and they look like this (they can be longer than 10mm as well)
2 ea: M3 x 14mm screws (For guide pins)