1 / 5
Body, insert rings, and tool for Rockler router plates — image 1
1 / 5

Body, insert rings, and tool for Rockler router plates

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The body is installed with the standard table screws, and then the inserts can be installed with the tool.

Rating
0 / 5
Likes
5
Downloads
17
Makes
0
Views
83
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Share Alike

This uses the same idea as the Jessem router plates, but is designed for Rockler Pro Plates.  The insert holder is mounted to the Pro Plate to allow the inserts to be used.

I used white UV resin to highlight the text and alignment points.

Printing was done with ABS.

Note that the insert holder required printing supports in the area where the insert is installed. Since the holder and inserts need to be flush, I ended up mounting the holder ring on a lathe (I added a centering ring to align it with the tailstock dead center) and turning the holder edge to remove enough of the support material for the insert to fit flush.

I also needed to clean the template guide plate of leftover support material using a 35 mm Forstner bit (Porter-Cable 9-Piece Router Template Guide Set PC42000).

For the tool I used:

Tags