1 / 1
Arrma to Traxxas Wheelie bar adaptor — zdjęcie 1

Arrma to Traxxas Wheelie bar adaptor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

converts traxxas drag wheelie bar to fit some arrma models

Ocena
0 / 5
Polubienia
4
Pobrania
5
Wydruki
0
Wyświetlenia
101
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

This takes the mount for the standard ARRMA wheelie bar on most brushed models and most 3s and 4s models and adapts it to accept a Traxxas wheelie bar. The Screw holes are a little tight and may need to be opened up slightly by turning the screw in and back out little by little or by using a thread tap. It fits standard Traxxas drag slash wheelie bars. i ended up 3d printing a slightly longer wheelie bar for it.

NOTE: the actual bumper may need to be trimmed depending on the wheelie bar that is used!

i used standard PETG at 6 walls, 6 top, 6 bottom, 30% Gyroid Infill, .28 layer height and printed it on its side so that the layers went vertically and it make a very stout and probably overbuilt part. only used supports on the 2 ears that were sticking out and used an outer brim.