1 / 5
BadgeRail - a simple badge holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a simple badge holder, nothing more than a smooth edge around your badge.
- Ocena
- 4,889 / 5
- Polubienia
- 75
- Pobrania
- 558
- Wydruki
- 10
- Wyświetlenia
- 2104
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (12)Wydruki i komentarze (Wydruki: 10) (Komentarze: 13)Remiksy (3)Kolekcje (85)Powiązane
Simple badge holder V2 - Updated July 3rd 2025
What is there to improve about something so simple.. Still some things apparently. After printing literally hundreds of these for coworkers and friends over the past 6 years, this design has been proven durable and easy to print and use.
I made a few final changes (2025-07-03) based on feedback over the years:
- Slightly reduced the thickness to 3.6mm, so it can be printed with various common layer heights.
- Removed one of the side tabs since it would damage cards after frequent removal, and people seem to like rotating colors a lot. Cards remain tightly snapped in place even without it.
- Redid the hole so the same holder can be used with wider attachment loops, while remaining centered with smaller keyrings.
- Kept the original pill-shape and pin-shape holes too
- Added vertical orientation
- Added double-thickness holders that can hold two cards
- Combinations of all of the above
I print them with supports for the overhangs, but multiple people have reported that it prints just fine without them.