1 / 5
BadgeRail - a simple badge holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Just a simple badge holder, nothing more than a smooth edge around your badge.
- Rating
- 4.889 / 5
- Likes
- 75
- Downloads
- 558
- Makes
- 10
- Views
- 2,104
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
Simple badge holder V2 - Updated July 3rd 2025
What is there to improve about something so simple.. Still some things apparently. After printing literally hundreds of these for coworkers and friends over the past 6 years, this design has been proven durable and easy to print and use.
I made a few final changes (2025-07-03) based on feedback over the years:
- Slightly reduced the thickness to 3.6mm, so it can be printed with various common layer heights.
- Removed one of the side tabs since it would damage cards after frequent removal, and people seem to like rotating colors a lot. Cards remain tightly snapped in place even without it.
- Redid the hole so the same holder can be used with wider attachment loops, while remaining centered with smaller keyrings.
- Kept the original pill-shape and pin-shape holes too
- Added vertical orientation
- Added double-thickness holders that can hold two cards
- Combinations of all of the above
I print them with supports for the overhangs, but multiple people have reported that it prints just fine without them.