1 / 6
CYD NM RF Hat Enclosure / Case (Magnetic, 6x2mm Magnets) — zdjęcie 1
1 / 6

CYD NM RF Hat Enclosure / Case (Magnetic, 6x2mm Magnets)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Compact magnetic case for the CYD NM RF Hat. Dual antenna design with snap-fit lid using 6x2mm magnets.

Ocena
5 / 5
Polubienia
49
Pobrania
755
Wydruki
2
Wyświetlenia
2433
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a enclosure designed for the CYD NM RF Hat (commonly used with the Cheap Yellow Display). The case protects the electronics while keeping full access to the screen, antennas, and connectors.

The lid is secured using 6×2 mm magnets, allowing the enclosure to snap closed without screws. This makes it quick to open for development, firmware updates, or hardware changes.

The design provides clearance for dual antennas, keeps the display fully visible, and maintains a compact and sturdy form factor.

This model is loosely inspired by the design from Thingiverse, but the enclosure was redesigned and adapted specifically for the CYD RF Hat layout and magnetic assembly.

Inspiration:
https://www.thingiverse.com/thing:7305463

Features

  • Designed for the CYD RF Hat

  • Magnetic snap-fit lid

  • Uses 6×2 mm magnets

  • No screws required

  • Dual antenna clearance

  • Full screen visibility

  • Easy access to components

  • Hole for Stylus

  • Compact and durable enclosure

Hardware Required

  • 6×2 mm magnets (8x)

Magnets are designed to press-fit, but a drop of glue can help secure them if needed.

⚠ Check magnet polarity before inserting so the lid attracts instead of repelling.

Printing

Recommended settings:

  • Layer height: 0.2 mm

  • Infill: 15–20%

  • Supports: Not required

  • Material: PLA / PETG

  • The case bottom should be printed with supports

  • A brim is recommended for the stylus only.

Print orientation:

  • Base: flat on the bed

  • Lid: flat on the bed

Assembly

  1. Insert the 6×2 mm magnets into the base and lid.

  2. Verify polarity before installing.

  3. Install the CYD RF Hat board into the case.

  4. Place the lid — magnets will hold it securely.

Tagi