USB-C Portable Charger for Baofeng BF-9700
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screwless Portable Charger for the Baofeng 9700 radio. Designed for IP2326 USB-C charging module.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Portable Charger for the Baofeng BF-9700 radio. Designed specifically to house the IP2326 USB-C charging module.
Print Settings
Supports: Yes
Material: PETG (recommended for snap-fit flexibility)
Hardware Required
1x IP2326 USB-C charging board (e.g., AliExpress link, 2S, 32mm × 19mm)
Short pieces of wire
Soldering iron
Assembly
Thread the stripped wire ends through the holes in the front pegs to create the charging contacts. Pay attention to correct polarity.
Inside the rear box, press the wires under PCB
Solder the wires to your IP2326 board and seat the board into the cavity.
Snap the printed cover on.
Note: The cover features 3 internal support pillars that press against the PCB to hold it in place. Depending on your wire routing, you may need to trim these pillars slightly for the cover to snap completely flush.
IP2326 PCB LED Indicators
Solid red: The battery is fully charged
Solid red and blue: The battery is currently charging
Solid red and blinking blue: The PCB is not connected to the battery (or the battery is not detected)