1 / 7
USB-C Portable Charger for Baofeng BF-9700 — image 1
1 / 7

USB-C Portable Charger for Baofeng BF-9700

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Screwless Portable Charger for the Baofeng 9700 radio. Designed for IP2326 USB-C charging module.

Rating
0 / 5
Likes
2
Downloads
4
Makes
0
Views
73
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Share Alike

Portable Charger for the Baofeng BF-9700 radio. Designed specifically to house the IP2326 USB-C charging module.

Print Settings

  • Supports: Yes

  • Material: PETG (recommended for snap-fit flexibility)

Hardware Required

  • 1x IP2326 USB-C charging board (e.g., AliExpress link, 2S, 32mm × 19mm)

  • Short pieces of wire

  • Soldering iron

Assembly

  1. Thread the stripped wire ends through the holes in the front pegs to create the charging contacts. Pay attention to correct polarity.

  2. Inside the rear box, press the wires under PCB

  3. Solder the wires to your IP2326 board and seat the board into the cavity.

  4. Snap the printed cover on.

Note: The cover features 3 internal support pillars that press against the PCB to hold it in place. Depending on your wire routing, you may need to trim these pillars slightly for the cover to snap completely flush.

IP2326 PCB LED Indicators

  • Solid red: The battery is fully charged

  • Solid red and blue: The battery is currently charging

  • Solid red and blinking blue: The PCB is not connected to the battery (or the battery is not detected)

Tags