1 / 13
Xol Carriage for Monolith 9mm ( 6mm maybe?), better redesigned Belt clips — zdjęcie 1
1 / 13

Xol Carriage for Monolith 9mm ( 6mm maybe?), better redesigned Belt clips

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix of the XOL Monolith carriage, to use strong fully printed belt clips! no SLM part needed on higher tensions

Ocena
4,5 / 5
Polubienia
39
Pobrania
198
Wydruki
2
Wyświetlenia
948
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Since i had issues with the available options,  bending wedges or clips.. needing slm printed parts to use the higher tensions you can run with monolith... i decided to design my own clips fully printed that can take the higher tensions!
this design was heavily inspired by: 𝗧𝗵𝗲𝗩𝗼𝗿𝗼𝗻𝗠𝗼𝗱𝗱𝗲𝗿  9mm Belt clips for XOL  on the Monolith discord,  since his carriage was not A4T compatible i adapted the design and modified it to a A4T compatible XOL carriage,   this design could possibly also run with 6mm belts ( untested! ) 

2 versions, one using fully printed parts!

Version 1 only needs

  • 2x M3x12

  • 2x M3 Square nuts

  • 2x 3x30 pins

Version 2 needs extra 3mm ID 4mm OD tube 22mm - 22.5mm i used a Brass tube for this

EDIT:

23.06.2026 added a fix for the Clamps to now sit perfectly centered to the rails ( was off by 0.15mm ) 

23.03.2026 added a version that allows tucking away the excess belt


ATTENTION!  Pull the Belt tight around the tube, i found it easiest to screw the 3 pieces to gether, align the ends on one side, pull them around, and put the tube in afterwards to check if it fits in tight or has a small airgap!  on one of my images you see a little gap, this was cause the back side was 1 tooth loose!

then screw it tight from the back to lock the belt in, if the backpiece bows a little dont worry! it is only a secondary support and will be pushed flat and against the belt by the carriage!

the 2 front holes at the top use M3 HexNuts cause i was using a older carriage to model this, and only later put the rest from the new carriage on this!

Tagi