Xol Carriage for Monolith 9mm ( 6mm maybe?), better redesigned Belt clips
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of the XOL Monolith carriage, to use strong fully printed belt clips! no SLM part needed on higher tensions
- Rating
- 4.5 / 5
- Likes
- 39
- Downloads
- 198
- Makes
- 2
- Views
- 948
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Since i had issues with the available options, bending wedges or clips.. needing slm printed parts to use the higher tensions you can run with monolith... i decided to design my own clips fully printed that can take the higher tensions!
this design was heavily inspired by: 𝗧𝗵𝗲𝗩𝗼𝗿𝗼𝗻𝗠𝗼𝗱𝗱𝗲𝗿 9mm Belt clips for XOL on the Monolith discord, since his carriage was not A4T compatible i adapted the design and modified it to a A4T compatible XOL carriage, this design could possibly also run with 6mm belts ( untested! )
2 versions, one using fully printed parts!
Version 1 only needs
2x M3x12
2x M3 Square nuts
2x 3x30 pins
Version 2 needs extra 3mm ID 4mm OD tube 22mm - 22.5mm i used a Brass tube for this
EDIT:
23.06.2026 added a fix for the Clamps to now sit perfectly centered to the rails ( was off by 0.15mm )
23.03.2026 added a version that allows tucking away the excess belt
ATTENTION! Pull the Belt tight around the tube, i found it easiest to screw the 3 pieces to gether, align the ends on one side, pull them around, and put the tube in afterwards to check if it fits in tight or has a small airgap! on one of my images you see a little gap, this was cause the back side was 1 tooth loose!
then screw it tight from the back to lock the belt in, if the backpiece bows a little dont worry! it is only a secondary support and will be pushed flat and against the belt by the carriage!
the 2 front holes at the top use M3 HexNuts cause i was using a older carriage to model this, and only later put the rest from the new carriage on this!