Bee Feeder with ground pin (Remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bee feeder that could be fixed in ground to stay in place and stabilize the feeder itself.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 165
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
We liked the idea of having something for insects like bees to feed them through the tough and hot summers with less and less rain falls. As we wanted to have a fixed place within our flower bed or flower pot, we thought of adding some ground pin to the feeder, so that we can put it at a fixed position and stabilize the feeder for frequent use.
Print Orientation (Ground Pin)
The ground pin could be printed on one of its converging sides in an angled position. Then only a small brim for the contacting area and a small support for the beginning is needed (see picture of print).
In my opinion this is the best solution, as this angled print will strengthen the print due to preventing layer lines in direction of force, if fixed in the ground. Also the four pins for glueing feeder and pin together are printed stronger as they were also anchored more into the other part of the ground pin.
Print Settings (Ground Pin)
The following print settings worked well for me:
Layer Height: 0,2mm
Material: PETG
Nozzle: 0.4mm
Perimeters: 4
Infill: 15%
Extra perimeters if needed and on overhangs (experimental)
Printed with brim (10mm) and bed supports.
How To Assemble
As the base was modified with four through holes, you have to glue in the pin with superglue. Therefore just put glue on all parts facing the feeder (also around the four pins) and in the pin holes. The glue should also act as a seal, so water isn't dripping.
After putting everything together, I also glued all around the touching areas, too, so that there is a chance for the glue to fill in gaps in the contacting areas.