1 / 5
Bee Feeder with ground pin (Remix) — image 1
1 / 5

Bee Feeder with ground pin (Remix)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Preliminary estimate for PETG

€2.66 – €3.25 net (excluding VAT)

For file: Grid_0.4n_0.2mm_PETG_COREONE_3h7m.bgcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €2.96 excluding VAT (range midpoint).

Weight reported by the author
36 g
Print time reported by the author
3.12 hr
Source material
PET
Estimate material
PETG
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

Bee feeder that could be fixed in ground to stay in place and stabilize the feeder itself.

Rating
0 / 5
Likes
6
Downloads
16
Makes
0
Views
165
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

We liked the idea of having something for insects like bees to feed them through the tough and hot summers with less and less rain falls. As we wanted to have a fixed place within our flower bed or flower pot, we thought of adding some ground pin to the feeder, so that we can put it at a fixed position and stabilize the feeder for frequent use.

Print Orientation (Ground Pin)

The ground pin could be printed on one of its converging sides in an angled position. Then only a small brim for the contacting area and a small support for the beginning is needed (see picture of print).

In my opinion this is the best solution, as this angled print will strengthen the print due to preventing layer lines in direction of force, if fixed in the ground. Also the four pins for glueing feeder and pin together are printed stronger as they were also anchored more into the other part of the ground pin.

Print Settings (Ground Pin)

The following print settings worked well for me:

Layer Height: 0,2mm
Material: PETG
Nozzle: 0.4mm

Perimeters: 4
Infill: 15%
Extra perimeters if needed and on overhangs (experimental)
Printed with brim (10mm) and bed supports.

How To Assemble

As the base was modified with four through holes, you have to glue in the pin with superglue. Therefore just put glue on all parts facing the feeder (also around the four pins) and in the pin holes. The glue should also act as a seal, so water isn't dripping.
After putting everything together, I also glued all around the touching areas, too, so that there is a chance for the glue to fill in gaps in the contacting areas.

Tags