Front Sight Replacement for Mendoza Air Rifle (Cal. 5.5) – 3D Printed PETG, Multi-Material
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this front sight as a replacement for a broken one on my Mendoza 5.5 caliber air rifle.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 80
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
I designed this front sight as a replacement for a broken one on my Mendoza 5.5 caliber air rifle.
The design was optimized to be printed in PETG for durability, and includes a visible green front sight tip made using a filament change during printing.
Printing Instructions
Material: PETG recommended
Layer height: 0.18 mm
Walls: 3 perimeters
Infill: 15–20%
Supports: Required (for the gray/main body piece)
Multi-material Tip
The green front sight was printed using a manual filament change.
Pause the print at the correct layer and switch to a bright or translucent filament for better visibility (I used recycled green PET from a bottle).
Alternatively, the whole piece can be printed in a single color and painted.
Assembly
The main body is printed as one piece.
The front sight insert is press-fit, but depending on your printer tolerances, it may fit slightly loose or tight.
If needed, a small amount of super glue can be used to secure it in place.
Notes
Designed and tested on a Mendoza 5.5 caliber air rifle
Fitment may vary slightly on other models
Adjust tolerances depending on your printer calibration
This part is intended for air rifles only
If you find this useful or improve the design, feel free to share your version.