1 / 1
Downrigger Shuttle
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3d printable version of a common down rigger accessory.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I whipped up a simple model of a "shuttle hawk" type device. It uses a .490 50 cal lead ball as the weight.
The original intent was to upscale this for larger baits but I had no problem with a big trout plug. Perhaps smaller would be better for lighter kokanee dodge rigs. Give it a try!
You will need to set a pause in your slicer before the lid goes on to insert the ball. Print large flat side down.
Tested with PETG, works like a champ! It did however fill with water on the test run which did not effect performance.