1 / 1
Downrigger Shuttle
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 3d printable version of a common down rigger accessory.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 102
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I whipped up a simple model of a "shuttle hawk" type device. It uses a .490 50 cal lead ball as the weight.
The original intent was to upscale this for larger baits but I had no problem with a big trout plug. Perhaps smaller would be better for lighter kokanee dodge rigs. Give it a try!
You will need to set a pause in your slicer before the lid goes on to insert the ball. Print large flat side down.
Tested with PETG, works like a champ! It did however fill with water on the test run which did not effect performance.