Elecraft KH1 Magsafe Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A clip-on cover for the logging tray of the Elecraft KH1 that allows you to attach a MagSafe compatible Magnet Sticker.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
PETG Recommended
Print on edge to allow for maximum strength when clipping and unclipping. It prints without supports. Make sure your print bed is CLEAN, there is not a lot of contact area on the first layer. If it struggles to print, use a brim or a raft.
If you like to use a cell phone app for logging contacts, this is for you! The paper tray on the KH1 is great, but sometimes I like to log on my phone. This mount clips over the logging tray, you can even leave the paper logs in place while using this mount. Get a MagSafe compatible magnetic sticker (link to the one I used below) and stick in on this mount. Get a MagSafe compatible case for your phone, and you can slap your phone on the logging tray. It clips on and off easily.
Be careful when using, Your phone is a lot heavier than the little slips of paper the logging tray was designed for. I haven't seen any damage yet on mine, but you are responsible for your stuff.
Link to magnetic sticker I used: