Liczymy pasujące modele…
BACKGROUND: The Elecraft KH1 blew up the portable HF radio operating scene when it was released. It covers 5 bands from 40 - 15 m and has an internal ATU and battery. It's actually designed for hand-held use. But with the standard whip…
This is a protection cover for the Powerswitch on your Elecraft KH1. It helps to protect your PA of any damage and empty batteries. Material PETG Layer height ≤0,1 mm Infill 100% Support None. The model was designed not to require any…
Edited 2/28/26 with new links for the items needed. I am open to improvements and tweaks - please contact me directly or leave a comment. I designed this KH1 kneeboard for some friends in the amateur radio CW community. In addition to the…
Designed specifically for the Fox ESS KH10 , this mount likely fits a wide range of Fox ESS models . If your inverter has heatsink fins approximately 2.7mm thick with a 12mm pitch (center-to-center) , this mount will clip directly onto…
Replacement handle for Bifinett KH1204 Customize This thing was made with Tinkercad. Edit it online Print Settings Printer: Anet A8 Rafts: No Supports: No Resolution: 0,2 Infill: 10% Category: 3D Printing
I wanted a case for my N6ARA tiny paddle so that I didn't have to worry about the arms getting bent while it was in my pack. The inspiration for the design came from this case for the Bamatech TP-iii.
The Elecraft KH1 HF radio comes with a 2600mAh battery which is huge capacity for that radio that would for four or five activations easily with that QRP radio. If you are only going out for a single activation or two a smaller battery is…
This is a stand that is for desk use or in the park. Any where you need to operate from. You can print this in any material you want I printed mine in petg. 15% infill no supports. You will need 2 10mm dia x 4mm thick. Not in the pic is…
Desk Stand for the Elecraft KH1. You can print it using PLA Or better. Infill 15% walls 2. Supports a must. I used Auto tree supports. The tabs on the sides are for Shock chords same as I used on my knee board.
This model comes with an opening on its side and bottom, so you can leave the USB-C cable attached to the cutter when putting it on the wall. You can use a cable holder then to keep the other USB-C end attached to HSW. Print the holder as…
PETG Recommended Print on edge to allow for maximum strength when clipping and unclipping. It prints without supports. Make sure your print bed is CLEAN, there is not a lot of contact area on the first layer. If it struggles to print, use…
This is a progressive modification of my KX2 cup mount for the KH1. Great for mobile CW ops or POTA activation. Print the two attached files along with this file for the mount swivel: Swivel Mount Low-Profile AMPS (30x38mm) Swivel Mount…
PETG Recommended Print on edge to allow for maximum strength when clipping and unclipping. It prints without supports. Make sure your print bed is CLEAN, there is not a lot of contact area on the first layer. If it struggles to print, use…
