SV08 XOL/A4T Toolhead X Gantry
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SV08 XOL/A4T Toolhead X Gantry Remix to allow for full X travel and proper parallel belt alignment for XOL/A4T and more
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 69
- Wydruki
- 1
- Wyświetlenia
- 666
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
SV08 XOL/A4T Toolhead X Gantry Remix to allow for full X travel and proper Parallel Belt Alignment for XOL/A4T. Untested with A4T but Based off CAD file it should line up perfectly.
Before the remix the belt pulleys were -1.5mm making the belts bend at a bad angle near end of Left/Right Travel and causing vibration and cracking noises when printing. I moved All pulleys forward +1.5mm and now the belts are perfectly 90 deg to each other in all directions.
Adjusted Heat Set Insert size adjustments as the 4mm hole was to large for a 4mm insert.
Added a clearance notch in Upper Right Gantry cover to allow for full X travel for XOL
This belt alignment will work for any toolhead on a SV08 with 5mm between the flat/top of the X Linear Rail and the back of the belt at the toolhead belt mounting bracket as shown in Picture
My Resonance Settings (Input Shaper) went from a bad X/Y setting to both MZV 42.3(X) and 54.1(Y) after this mod
Recommended Print Settings
Material: ABS or ASA
Orientation: Already set by file orientation
Walls/Perimeters: 5
Top/Bottom Layers: 5
Infill: 30-40% (TPMS-D or Gyroid recommended).
Scaling/Shrinkage: Print at 100% scale. USE shrinkage compensation
Supports: Needed (Shown in photo of where it is needed)
BOM
8x M3x8mm SHCS or BHCS
2x M3x30mm SHCS
2x M3x40mm SHCS
2x M4x30mm SHCS
2x M5x30mm SHCS
2x M5x40mm SHCS
*4x M3 (4mm Long) HSI (Heat Set Insert)
*4x M4 (4mm or 6mm Long) HSI
*4x M5 (4mm or 6mm Long) HSI
*Heat inserts vary in diameter expect it to be a tight press in fit. Better to force it in then too loose and it strips out of the model if over tightened (I had that issue prior). Just run a screw of the correct size in and out a few times after install to clear the threads etc. if needed prior to install.*
**Also some screws may extend past the model. It was like this prior to my remix and I adjusted the BOM to be as minimal as possible for that without making a BOM of not popular sized length hardware for example-M5x37mm lol. Regardless this will not cause any issues with printing**