Silica Bead Desiccant Drying Container for SUNLU S2 Filament Dryer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dry/recharge your silica beads in your SUNLU model S2 filament dryer.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 183
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
All the parts for this model are the same as the original. I merely split the assembly into multiple files so they are easier to print. I've included an STL file for each part.
I oriented the parts to minimize the need for supports. I only used supports for the pouring spout's overhang. The curves are a bit steep at the bottom of the box, but my printer (P1S) handled it without supports.
The creator of the original design didn't mention the screws needed to mount the two feet to the bottom of the box. Based on the pilot hole size, I'm assuming that they are supposed to be M3. I used M3 x 12 with a flat washer.
I used PETG. ASA or ABS would also be good options. PLA would probably not hold up to the heat.