1 / 4
INDX 9mm/10mm belt mount for Vorons (standard belt path) — zdjęcie 1
1 / 4

INDX 9mm/10mm belt mount for Vorons (standard belt path)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An untested mount based on the original design.

Ocena
0 / 5
Polubienia
16
Pobrania
60
Wydruki
0
Wyświetlenia
549
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

A simple remix of the original for  up to 10mm belts. Uses 8mm panheads instead of taper screws - ignore the caps in the picture, I was lazy and they were closer. Does print useably without the supports but very clean print with them in ABS-GF.

*MGN mount is now button not taper screws because I have millions

Works perfectly for my setup with >2500 toolchanges.

Updated 19/7: Redrawn from scratch and now has a venting duct for the the rear cutout as part of the heat creep remedy. 

The slot also allows for routing of cables behind the toolhead to the endstop and eddy board of your choosing.

Endstop mount here: https://www.printables.com/model/1843969-indx-voron-endstopeddy-mount