1 / 4
INDX 9mm/10mm belt mount for Vorons (standard belt path) — image 1
1 / 4

INDX 9mm/10mm belt mount for Vorons (standard belt path)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An untested mount based on the original design.

Rating
0 / 5
Likes
16
Downloads
60
Makes
0
Views
549
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

A simple remix of the original for  up to 10mm belts. Uses 8mm panheads instead of taper screws - ignore the caps in the picture, I was lazy and they were closer. Does print useably without the supports but very clean print with them in ABS-GF.

*MGN mount is now button not taper screws because I have millions

Works perfectly for my setup with >2500 toolchanges.

Updated 19/7: Redrawn from scratch and now has a venting duct for the the rear cutout as part of the heat creep remedy. 

The slot also allows for routing of cables behind the toolhead to the endstop and eddy board of your choosing.

Endstop mount here: https://www.printables.com/model/1843969-indx-voron-endstopeddy-mount