Hauck Safety Gate Width Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy 4-part print to widen Hauck gates capabilities by 70mm.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 41
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
What Is It For
I bought a gate to keep my rabbit in the livingroom and the opening was too wide for the gate's 800mm adjustment so I came up with this.
This adds 70mm of width and I ended with two so I can keep the adjustment screws in as much as possible.
Installation
I Installed this with just some foam between the spacer and the wall to minimize damage to the wall and used the gate's tension to keep it in place and it has worked good so far. If there is a need for screw holes I can make the change and upload it.
Print Settings
For the ends you should have atleast 4 walls and 6 tops and bottoms with 20% infill as they take all the forces. The ends have 2 different models if you have baseboards like I have or not.
For the decorative parts in the middle you can use lighter settings as they are just that, decorative.
Printed mine in Azurefilm PETG Hyper Speed.
The Culprit
Last photo is of the 7kg bad boy who this jail is for.