Top Cover for CORE ONE /+ (magnetic, with or without hinges, no support)

I included the adapted part (+5mm) for the automatic vent block for the CoreOne+ as well here.

I know that there are a few top covers out there already for the Core One/+.

I made my own take on it since I wanted it to be as thin as possible and easy to assemble.

I also wanted to not have to use support while printing and to not have to use glue while assembling. :)

Configurable:

• Parts needed for cover with hinges (as shown on the pictures):

  • 3x "straight_standard.stl"

  • 1x "straight_with_hinges.stl"

  • 3x "corner_part1.stl"

  • 3x "corner_part2.stl"

  • 1x "corner_part1_with_handle.stl"

  • 1x "corner_part2_with_handle.stl"

  • 1x "hinge_left_side.stl" (make you sure print it in the right orientation)

  • 1x "hinge_right_side.stl" (make you sure print it in the right orientation)

If you don't want hinges just take 4 times the "straight_standard.stl" and leave the the hinge-parts out.

If you wonder: The pockets in the straight parts are there so that the print will more likely bend a little downwards after it's finished. Like that you get a tight fit between the part and the plexiglas cover.

You can also have as many or as little corners with handles as you want. Just choose the parts accordingly to your needs.

Other Materials needed:

• 8x M3x5 screws with 8x M3 standard nuts

• 2x M3x8 screws for the hinges

• 4x magnets 10x5x2 mm (depending on the strength of your magnets you can leave some of them out)

• 8x magnets 20x10x2 mm (depending on the strength of your magnets you can leave some of them out)

General: I made two pockets in each corner. One pocket has space for one 10x5x2mm magnet and the other pocket has space for two 20x10x2mm magnets. After assembly the pockets are all closed.  So if you use smaller magnets or leave some of them out it doesn't matter. No need for glue here.

Material and printsettings:

• Printer used: Core One

• PETG (in my case orange Prusament for the fitting colour)

• Standard Prusament PETG profile in PrusaSlicer 2.9.4

• 0.4mm HF Copper Noozle

• 0.2mm STRUCTURAL (I tried BALANCED as well and it also works fine)

Feel free to ask me if you want some changes or other sizes for the magnet pockets.

Also feel free to change the parts yourself to your needs. I added a .step-file of the whole frame.

I hope you like it.