Catalyst Machine Works - BangGod Frame - TPU Parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are prototype TPU parts for the Catalyst Machine Works 6" Frame. This is under contstruction, so expect changes,…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 262
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
These are prototype TPU parts for the Catalyst Machine Works 6" Frame. This is under contstruction, so expect changes, nothing is perfect yet.
CRSFAntennaHolder_v20.stl:
Antenna Mount for 1x TBS Hand-Tuned CRSF in the middle and 2x TBS Pro LHCP for the Air unit on the sides.
=> After printing I cut the two thin tubes along the full length on the front with an exacto knife, through this cut I then inserted the antenna-cable. I also added some shrink tube, but that is no really needed.
CRSFAntennaHolder_Mini.stl
Antenna Mount for 1x VAS Mini CRSF Antenna in the middle and 2x TBS Pro LHCP for the Air unit on the sides.
=> After printing I cut the two thin tubes along the full length on the front with an exacto knife, through this cut I then inserted the antenna-cable. I also added some shrink tube, but that is no really needed.
CRSFAntennaHolder_DjiOnly.stl
2x TBS Pro LHCP for the Air unit on the sides, no Antenna in the middle.
=> After printing I cut the two thin tubes along the full length on the front with an exacto knife, through this cut I then inserted the antenna-cable. I also added some shrink tube, but that is no really needed.
ledHolder_v3.stl:
LED Mount for this: https://www.catalystmachineworks.com/products/circular-rgb-led-board-sw316-an?_pos=10&_sid=5818da0e6&_ss=r
GPS_Mount_v4.stl:
Is only if you don't use a GoPro for this part: https://www.aliexpress.com/item/32917782967.html?spm=a2g0s.9042311.0.0.5e084c4dUY4j20
Print in TPU.
Category: R/C Vehicles