1 / 6
Lawn Mower Gas Throttle Handle (e. g. for Toro, Solo, ALKO etc.) — zdjęcie 1
1 / 6

Lawn Mower Gas Throttle Handle (e. g. for Toro, Solo, ALKO etc.)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement part for the handle used to control the gas Bowden cable in some older lawn mowers and other equipment

Ocena
0 / 5
Polubienia
4
Pobrania
11
Wydruki
0
Wyświetlenia
81
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

The handle consists of two different parts held together by screws. It is designed to fit on a sheet metal control rod of 2.2 mm width (see image for an example).

Handle length: 70 mm
Diameter: 25 mm
Height: 56.5 mm

Required material:

  • 1 x Cylinder head screw (ISO 4762) M8 x 60 mm (hex drive)

  • 1 x Self locking nut (ISO 7040 or ISO 10511) M8

  • 2 x Flat-headed screw M4 x 12

  • 2 x Self locking nut M4

Printing:

  • Material: PETG (preferred), PLA may work too

  • Layer height: 0.24 mm

  • Infill: 30 %

  • If your printer can handle 45 degree overhangs: To increase strength and reduce support material use try to print the parts obliquely as shown in the slicer view image

  • Brim: As required by printing orientation

  • Supports: As required by printing orientation; recommended style: Organic/Tree, on buildplate

Tagi