RoboPad PrintABlok Parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A collection of parts designed to make it easy to use the RoboPad and EduBoard with the PrintABlok system.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
These models are modifications of the base blocks that add bloks that allow for creation of robots using the RoboPad and EduBoard breakout.
Make sure you also download the professor's base PrintABlok sets to have the parts to build these robots with!
Itemised parts list:
9v Battery Blok: We needed a lighter-weight model than the one currently available in the CircuitBlok pack that could easily have the battery swapped in and out with no zip-ties or other tie-downs. For this we put together this blok. The 9v battery simply clips in on it's side.
9v Switch Bloks: These are two simple blocks made from the subtraction of a 1x2x1 block with a region for a small 3-position switch. Two variations are available, one that uses small M2 screws to attach the switch, and one that allows you to use an iron or hot plastic shaping tool to melt plastic in place of the screws.
N20 Blok: A block that compactly holds an N20 motor. Solder wires to the motor at 90 degree angles to the motor axel, and then snap the motor into the blok rear-first. Also provided is a remover tool that can be used by placing two long M2 bolt+nuts in it to act as a pusher to push a motor out of the block it is in.
RoboPad+EduBoard holder Blok: A block that holds the RoboPad+Eduboard PCBs.
Ski Bloks: Simple blocks that can be used as skiis under the front of a robot.