1 / 3
Oil mod parts for SR Suntour SF13-XCM fork — zdjęcie 1
1 / 3

Oil mod parts for SR Suntour SF13-XCM fork

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

parts used to convert SR Suntour XCM bicycle fork to oil lubrication instead of thick grease lubrication

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
133
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

SR Suntour SF13-XCM bicycle fork requires frequent maintenance, when used in hard conditions. Stock dust seals offer next-to-no protection from water and sand, so these polutants find their way into the fork, reducing it's lifespan, and decreasing performance.

To avoid the need for frequent maintenance and cleaning, I designed set of SR Suntour SF13-XCM compatible parts, that allow the use of automotive seals. This solution protects fork internals way better than stock dust seals, so it becomes feasible to use fork oil for internals lubrication, instead of thick grease. This results in better lubricated, cleaner and longer lasting fork, that requires less maintenance and cleaning.

The set contains folowing parts:

  • XCM seal adapter.stl - this is designed to hold automotive style oil seal (30x40x7 - bought separately), insted of stock dust seal. It is seated into the lowers, replacing stock dust seal. Silicone sealant is recomended.

  • SR Suntour SF13-XCM top cap.stl - this is designed to replace preload adjusters, since they do not seal against oil. Use of teflon sealing tape is recomended on threads (bought separately). Once you figure out your desired preload level, you can choose to print corresponding cap (100%-75%-50%-25%-0% preload). Preload can not be adjusted on the go - this is the tradeoff for lower maintenance.

  • SR Suntour SF13-XCM bottom stopper.stl - I found mine to be cracked, so here's a replacement. Not really needed for oil mod, if yours is ok.

Also, when assembling the fork, use of silicone sealant is recommended for lower nuts as well - both threads and seats. Just in case. 

For lubrication I used ~50 ml of fork oil (10W) into each stanchion. Viscosity does not matter much, since oil only lubricates internals, and does not perform any damping. You might want to turn bicycle upsidedown now and then, to introduce oil from the bottom of the fork to upper internal surfaces. Though under heavy riding it will lubricate everything naturally just fine.

Tagi