T300 adapter for HGX lite extruder and X1C hotend
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Comgrow T500 Bambu Hot End Adapter V2 by 09williamsad on Thingiverse.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
My original T300 extruder broke twice so I wanted to make something that allows for easier maintenance. Currently still in a working prototype status this was printed in PLA+ at a 45° angle to increase strength of the print. I used 3mm heat inserts for all of the screw points as well as 3mm screws.
All of the holes line up correctly for proper mounting of HGX lite extruder HGX-LITE Extruder All Metal Hardened Steel Reduction Gear Extruder 3D Printer Parts,Upgraded Big Gear POM Material Drive for Vorn 2.4V0 Ender 3 CR-10 CR10S 3D Printer
Also used a X1C hotend
X1, X1C Hotend Complete Kit, Complete Assembly for Bamboo Lab X1 Series 3D Printer, 0.4 mm Hardened-Steel Nozzle, Ceramic Heater, Thermistor, Fan and 3D Printers Extruder Heating Block Replacement
I used the original fan for the T300 in place of the 5VDC fan for the X1C heatsink. I also used the original stepper motor that fits perfectly on the HGX lite.
The toolhead board is a little close and needs a different orientation due to the stepper motor plug being too close to the extruder and hard to plug in. I also had to extend and reuse the original connectors.
I was able to configure the z offset and changed the x location for the probe since it sits further away from the original location in the printer.cfg
Calibrated the z offset and flow with a simple 1 layer print. Also printed a calibration cube. The PLA+ has been holding up so far but plan to print this in PETG or PC eventually after changes are made in the next version.