1 / 1
T300 adapter for HGX lite extruder and X1C hotend — image 1

T300 adapter for HGX lite extruder and X1C hotend

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix of Comgrow T500 Bambu Hot End Adapter V2 by 09williamsad on Thingiverse.

Rating
0 / 5
Likes
2
Downloads
15
Makes
0
Views
81
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

My original T300 extruder broke twice so I wanted to make something that allows for easier maintenance. Currently still in a working prototype status this was printed in PLA+ at a 45° angle to increase strength of the print. I used 3mm heat inserts for all of the screw points as well as 3mm screws.

All of the holes line up correctly for proper mounting of HGX lite extruder HGX-LITE Extruder All Metal Hardened Steel Reduction Gear Extruder 3D Printer Parts,Upgraded Big Gear POM Material Drive for Vorn 2.4V0 Ender 3 CR-10 CR10S 3D Printer

Also used a X1C hotend 
X1, X1C Hotend Complete Kit, Complete Assembly for Bamboo Lab X1 Series 3D Printer, 0.4 mm Hardened-Steel Nozzle, Ceramic Heater, Thermistor, Fan and 3D Printers Extruder Heating Block Replacement

I used the original fan for the T300 in place of the 5VDC fan for the X1C heatsink. I also used the original stepper motor that fits perfectly on the HGX lite.

The toolhead board is a little close and needs a different orientation due to the stepper motor plug being too close to the extruder and hard to plug in. I also had to extend and reuse the original connectors. 

I was able to configure the z offset and changed the x location for the probe since it sits further away from the original location in the printer.cfg

Calibrated the z offset and flow with a simple 1 layer print. Also printed a calibration cube. The PLA+ has been holding up so far but plan to print this in PETG or PC eventually after changes are made in the next version.