ZWQ S400 - Rear QD point
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
QD point that uses the upper magwell chicago screw
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
A rear angled free swivel QD point for the ZWQ S400
Makes use of the upper chicago screw that holds the magwell in place.
Fits the threaded screw, not the internally threaded post.
Ideally replace the screw with one of the slightly longer ones, I used one of the 15mm screws.
Prints OK without supports with the flat face to the plate See 20/05/26 update
Won't fit with the factory cheek rest (without some trimming) See 26/03/26 update
Also a big thank you to ZWQ for providing the blaster shell STL, and IFB for hosting them. Makes life a lil' bit easier.
Update: 26/03/26
Added versions with cutouts to fit the OEM cheek rest. Should still print OK with no supports
Update: 20/05/26
I found printing with the face of the QD hole flat to the plate much better for lower resolution printing. At 0.16, printing in the original orientation can lead to the QD insert slipping out due to the circular interface slicing as a bit too ovoid.